Jlg 10MSP Operator Manual Manual de usuario descargar pdf (Pagina 44)

SECTION 3 - MACHINE OPERATION

3-16 – JLG Lift – 3121227

Drive Motor Brush Wear Warning

(Counts down 25 hrs. of DRIVE

operation remaining to a 10 sec.

shut down mode)

Drive Motor Brushes Require Ser-

vice Replacement -

(See Section 5.7 on page 5-16 for

further Instructions)

13 6

Traction Module Over Temperature

(DRIVE Disabled)

Allow Drive System Traction Mod-

ule to Cool Before Operating

(Caused by extreme temperature)

17 7

Ground Control Module Over Tem-

perature (Machine Stopped)

Allow Ground Control Module to

Cool Before Operating -

(Caused by extreme temperature)

32 7

Pump Motor Over Current

(LIFT UP Disabled)

Platform Load Over Capacity

34 —

Aux. #1 - Platform Gate Open or

No Pres sur e on th e Pl atfor m Foot-

switch

Close Platform Gate or Depress

Platform Footswitch during

machine operation

35 —

Aux. #1 - Platform Footswitch

depressed during Machine Power-

Do Not Press on Platform Foot-

switch during Machine Power-Up

NOTE: The fault conditions shown in this table are fault conditions which the Operator may be able to resolve. Should a fault occur which cannot be cor-

rected at the Operator’s level, the problem must be referred to a mechanic qualified to repair this model of JLG Lift. A complete table of Fault Codes

is listed in the TroubleShooting Section of the Service and Maintenance Manual.

Table 3-2. LCD Display - Operating Fault Conditions (Continued)

FAULT

CODE

PLATFORM

LEDs

FLASHING

LCD SYMBOL SCREEN LCD TEXT SCREEN

FAULT DESCRIPTION/

MACHINE CONDITION

TO CORRECT PROBLEM

00000. 0