Jlg 10MSP Operator Manual Manual de usuario descargar pdf (Pagina 25)

SECTION 2 - PREPARATION AND INSPECTION

3121227 – JLG Lift – 2-7

Walk-Around Inspection Components

Reference - Figure 2-1. on page 2-6

NOTE: On all components, make sure there are no loose or miss-

ing parts, they are securely fastened, no visible damage,

leaks or excessive wear exists in addition to any other cri-

teria mentioned.

1. Front Caster Wheels - Check for any debris stuck to or

around wheels.

2. Base Frame - Check for loose wires or cables dangling

below the base.

3. Batteries (one each side of machine) - Not leaking; bat-

tery cables secure to posts; no corrosion.

4. Rear Drive Wheels - Check for any debris stuck to or

around wheels.

5. Mast Assembly - Mast sections; slide pads; mast

chains; sequencing cables; platform control and power

cables (on side of mast); power cables properly ten-

sioned and seated in sheaves; cable sheaves rotating

freely.

6. Motor/Pump/Reservoir Unit - No evidence of hydraulic

leaks. Hydraulic oil level should be filled level with the

full line on the dip stick.

7. Ground Control Station - Main Power Switch (Key)

operable; placards secure and legible; emergency stop

switch operates properly.

8. Manual Descent Control Valve - See note before item-

9. Platform Control Console - Platform control; placards

secure and legible; emergency stop switch reset for

operation; Control markings legible.

10. Platform Assembly and Gate - Platform railings; entry

gate in proper working order, closing properly.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 95 96

Sin comentarios

Jlg 10MSP Operator Manual Manual de usuario Pagina 25